It can be really annoying if your Lorex camera abruptly stops recording, especially when you need it most. In most cases, it's a minor problem that can be resolved in a matter of minutes. Let's go over a few easy things you can do to restart your machine.

Examine the storage first.

Your Lorex Camera Not Recording problem may appear if your storage is full. Check to see if the SD card or hard disk is full by opening your system settings. If so, turn on overwrite mode or remove the old footage.

Verify that motion detection is enabled.

Sometimes cameras are programmed to only record when they sense motion. Nothing is recorded if motion detection is turned off. If necessary, go to settings and activate it.

Check the recording schedule.

It's possible that your camera is not configured to record continuously. Verify whether the recording schedule reflects your preferences for motion-based or continuous recording.

Verify your internet connection.

Recordings may be halted by a poor or failed connection, particularly in cloud configurations. Make sure your camera is linked to a reliable network while using the Lorex WiFi camera setup.

Give your device a restart.

Although it sounds simple, this is effective. Restart your DVR/NVR system and camera. It fixes transient flaws that could interfere with recording.

Examine the electricity and cables

Recording may stop due to loose wires or power outages. Verify that the camera is receiving electricity and that everything is connected correctly.

Firmware update

Problems may arise from outdated firmware. Look for and install any updates that are available in your system settings.

Verify the system or app settings.

Unintentionally, settings can occasionally be altered. Verify your app's storage settings, alerts, and recording modes again.

Once you know where to go, fixing the Lorex Camera Not Recording issue is typically quick. Just go step by step, and you’ll likely have your camera recording again in no time. Visit our webpage to know more.